![]() When you reboot in failsafe mode, the device starts up in a basic operating state, with a few hard coded defaults, and you can begin to fix the problem manually.įailsafe mode cannot, however, fix more deeply rooted problems like faulty hardware or a broken kernel. after a configuration error, then failsafe mode is there to help you out. If your device becomes inaccessible, e.g. Previous testing was done with the R6300 and WNDR4500 routers prior to the addition of the advanced options.OpenWrt allows you to boot into a failsafe mode that overrides its current configuration. It has been tested with the Netgear RAX80 router. get_attached_devices (): print i Supported routers To use within your Python scripts: from pynetgear import Netgear netgear = Netgear ( password = mypassword ) for i in netgear. $ python3 -m pynetgear_enhanced -p='MyEscapedPassword!' -check_fw -t You can install pyNetgear_Enhanced from PyPi using:įor a list of commands run from the console:įor testing append a -t to the command from the console. Return a dict containing the 5g Guest Network Info. Return a dict containing the 2.4g Guest Network Info. Return a dict containing the 2.4g WPA Key. Return a dict containing the Status of 5g Guest Wifi. Return a dict containing the Status of 2.4g Guest Wifi. Return a dict containing the Bandwidth Control Options. Return a dict containing the Status of QOS. You will have to wait several seconds following starting the speed test to get the final results. Return a dict containing the Speed Test Results. This call is slower and probably heavier on the router load. Returns a list of named tuples describing the device signal, ip, name, mac, type, link_rate, allow_or_block, device_type, device_model, ssid and conn_ap_mac. Returns a list of named tuples describing the device signal, ip, name, mac, type, link_rate and allow_or_block. Return a dict containing the Supported Features. Return a dict containing the Router Information. Return a dict containing the DNS Masq device IDs. Return a dict containing the MAC Addresses. Return a dict containing the Status of Parental Control. Return a dict containing the Traffic Meter Options. Return a dict containing the Status of Traffic Meter. Return a dict containing the traffic meter information from the router (if enabled in the webinterface). Return a dict containing the Status of Access Control. Return a dict containing the Firmware info. Note: In order to use this function, Remote Management must be enabled in the router's admin settings. Will return True or False to indicate success.Īllows user to block/unblock devices from accessing router by specifying mac_addr and new device_status (Block/Allow) It currently supports the following operations: This allows the use of HTTPS, for example. You can specify url and it will take precedence on host/port/ssl parameters. If you are connected via a wired connection to the Netgear router, a password is optional. If you are connected to the network of the Netgear router, a host is optional. It is built by reverse engineering the requests made by the NETGEAR Genie app. It uses the SOAP-api on modern Netgear routers to communicate. PyNetgear_Enhanced provides an easy to use Python API to control your Netgear router. ![]()
0 Comments
Leave a Reply. |